CAUTION
Do not turn the starter motor for more than 5 seconds. If the
engine does not start after 5 seconds, release the starter
button.
Wait at least 15 seconds before trying to start the engine
again.
If the starter motor is engaged continuously for more than 5
seconds, the battery will be quickly discharged and it will be
impossible to start the engine.
The starter motor may also be damaged if it is engaged
continuously.
Do not connect the end of the jumper cable to the negative (-)
terminal on the Jet boat battery. Be sure all connections are
secure and correct before attempting to start the engine. Any
wrong connection may damage the electrical system.
CLEANING THE JET INTAKE IMPELLER
•
If weeds or debris get caught in the intake or impeller, cavitation can occur, and
though the engine speed rises, forward thrust will decrease.
•
If this condition is allowed to continue, the engine may overheat and seize.
•
If there is any sign that the jet impeller is blocked with weeds or debris, either beach
the jet boat, place it on a trailer or on chocks and check the intake and impeller.
•
Always stop the engine before beaching the Jet boat.
•
Remove or debris from around the drive shaft, impeller, pump housing and steering
nozzle. If it is difficult to remove consult your dealer.
WARNING
Before attempting to remove weeds or debris from the jet
intake or impeller areas, shut off the engine and remove the
lock-plate from the stop switch.
CAUTION
Always avoid running your Jet boat in areas where weed
growth is thick. If travelling in weed areas is unavoidable, run
the engine alternately at partial-throttle and full- throttle.
Weeds tend to accumulate more at a steady speed and at a
trolling speed.
If weeds clog the intake or impeller area and cause cavitation,
follow the above cleaning procedure.
WARNING
Do not attempt to turn your Jet boat over to gain access to the
jet intake. Water may flow back from the exhaust to the
cylinder heads causing severe engine damage.
44
