AVM OVATION MP 6.3, Руководство по эксплуатации

Страница: 19 / 30

19
ü
Call up the Settings of the RC X App . In the Version section, you can view details about
the currently installed firmware version.
To install a software update via a USB stick, please consult your dealer who will be happy to
assist you with the update.
1.11.2 AVM X-STREAM Engine® Update via the RC 9 remote control
ü Select the desired AVM device on the
RC 9
using the menu item
Device Selection
. You
can reach this menu item via the
System
menu, which you call up by pressing the
Settings
button (tool symbol) on the
RC 9
.
ü
On the
RC 9
, select the menu item
Settings
in the main menu by pressing the upper or
lower navigation button several times.
ü
Call up the menu item Firmware Update and select Check for Online Update .
ü
If a new version is available under
SW Update
or
Host Update
, install it by clicking
Install
Update .
ü
The device restarts to install the update. Do not switch off the device and wait until the
update process is completely installed. The update process will be shown on the display of
the device if necessary.
ü
Once the update process is complete, the device will reboot and be ready for use again.
ü
Select the menu item Settings in the main menu by pressing the upper or lower navigation
key several times. In the Version section you can view details about the currently installed
firmware version.
To install a software update via a USB stick, please consult your dealer who will be happy to
assist you with the update.
1.12 External infrared control
The connector for an external infrared receiver (37) may be used to control the AVM device with
an external infrared signal. For this purpose, the cable coming from the external receiver must
be assembled with a 3.5 mm stereo jack plug. The voltage output must also have a logic level
(LOW < 0.4V, HIGH >2.4V, max 5V).
Pin assignment for external infrared receiver (37)
3,5mm stereo
+5V supply IR-Signal GND
infrared input