IP POWER 1U USER MANUAL
4. Hardware & Software installation
Before you star to use IP Power 9258-1U, please follow the steps below
Check the package to make sure the contents is complete.
Prepare one Ethernet HUB or Router
Check the voltage of the power supply to make sure it is AC 110-240 volt
Please confirm the specification of your power cable.
* For
220-250V
, please use power cable at MAX 10A for each 4outlet.
* For
100-120V
, please use power cable at MAX 15A for each 4outlet.
Hardware installation
1
Connect the IP Power to a HUB with a RJ45 cable or network cable.
2
Connect the HUB or Router to the internet (May through ADSL/XDSL modem).
3
Connect the power adapter to the IP Power 9258-1U.
4
Connect the power adapters of under control electric equipment to corresponding
out port of IP Power 9258-1U.
Turn on your computer and the power adapter of IP Power 9258-1U
* For 220-250V, please use power wire can support 10A current.
Max. output current: (total of each four outlets) 10A, (each outlet) 6A.
• for
100-120V
, please use
power wire can support 15A current.
Max. output current: (total of each four outlets) 15A, (each outlet) 6A
Software Installation
Please follow the steps below to install the software.
1. Insert the Installation CD in the package and windows will auto-run. If not please browse for the
Autorun.html file in CD.
.
2. Click
IPEdit
in the downloads section of the installation CD
3. Save IPEdit to your desktop or any other place of your choosing
4. After you have saved it onto your desktop and double click to run it.
- 8 -
