In this case, the 9070-IR is being connected to the internet through a hub, which is different from
a router. The hub does not provide DHCP, and therefore would require that this setup have a
static IP Address that is provided by the ISP.
Contact the ISP to find out the static IP address so that your device can be accessed through the
internet. Once a Static IP has been assigned the device will be able to automatically go onto the
internet. .
CS Lens
1.) Carefully remove the lens from the box and the IP Kamera9070-CS PoE.
2.) Remove the cap from the IP Kamera9070-CS PoE.
3.) Remove the back cap from the lens
4.) Then slowly screw in the lens to the IP Kamera9070-CS PoE in a clockwise direction to
tighten.
5.) Finally Remove the front lens cap.
6.) Loosen the lens focus screw and adjust the lens to your own liking. Turn the screw
counterclockwise to loosen and clockwise to tighten the focus
7.) Adjust the lens to your own special requirements.
Connecting the Device
1.) Connect the IP Kamera 9070 to a HUB or Router with a RJ45 network cable.
2.) Connect the HUB or Router to the internet (May through ADSL/XDSL modem).
3.) Connect the power adapter to the DC 12V port of IP Kamera 9070.
SD Card
Simply place the SD card in the back of the9070-CS PoE with the face of the SD card facing down.
5.) Software Setup
The software for the device is located on the
Media Link-IP Family CD
that came with the device.
IP Kamera Pack is located on the main page of the CD. Please follow the directions carefully and
install the necessary files
Software for IP Kamera9070-CS PoE
Software for IP Kamera 9070
1.) First place the
Media Link-IP Family CD
that came with your device into your CD/DVD Rom drive.
The CD should auto run but if it does not go to the CD/DVD Rom drive and select the file
“
autorun.html
”.
-
12-
Ref#90020326K0709
