18
Av-P2 O
utPut
M
Odule
u
ser
G
uide
Connecting Audio
The audio outputs on the AV‑P2 Output Module can be connected to
balanced or unbalanced devices via the Euroblock jacks.
Wiring a Euroblock
Euroblock connectors provide an easy, solder‑free way of making audio
connections between the AV‑P2 and other audio components. Only a small
flat‑blade screw driver is required to make connections. For extra strength,
you can add solder to each bare wire on an audio cable to stop the wire
strands from unwinding (called “tinning”).
LEFT
DC
POWER
RIGHT
OUT
IN
AUDIO OUTPUT
AV-P2
+ –
+ –
18-24 VDC
500mA
AV-P2 left/right Euroblock audio outputs
Connecting to a Balanced Device
To connect the AV‑P2 Euroblock audio output to a device that can accept a
balanced line‑level input:
Strip the insulating jacket of the cable back about .75 inch
1.
(18 mm) to reveal the individual hot, cold, and ground
wires within.
Remove a small amount of each individual wire’s insulation
2.
(approximately .25 inch, 6 mm).
On the 5.0 mm Euroblock male plug, use a small screw
3.
driver to loosen and open the sockets that will receive the
individual wires.
Insert the individual hot (+), cold (‑), and ground wires into
4.
the matching sockets on the Euroblock plug.
Tighten the screws on the wire sockets to secure the
5.
individual wires.
Plug the completed Euroblock plug into the desired output
6.
channel on the AV‑P2.
Connect the AV‑P2 to your audio device.
7.
