20
Av-P2 O
utPut
M
Odule
u
ser
G
uide
Two-conductor shielded cable
To connect the AV‑P2 audio output to an unbalanced line‑level device using
two‑conductor shielded cable:
Strip the insulating jacket of the cable back about .75 inch
1.
(18 mm) to reveal the individual hot and ground wires
within.
Remove a small amount of each individual wire’s insulation
2.
(approximately .25 inch, 6 mm).
On the Euroblock plug, use a small screw driver to loosen
3.
and open the sockets that will receive the individual wires.
Insert the audio cable’s hot (+) wire into the matching
4.
socket on the Euroblock plug.
Insert the audio cable’s cold (‑) wire into the matching
5.
socket on the Euroblock plug.
Insert the audio cable’s ground wire into the matching
6.
socket on the Euroblock plug.
Tighten the screws on the wire sockets to secure the
7.
individual wires.
Plug the completed Euroblock plug into the desired output
8.
channel on the AV‑P2.
At the other end of the cable, connect the hot (+) wire to
9.
the unbalanced device’s hot connector.
Connect the cold (‑) and ground wire to the unbalanced
10.
device’s ground connector.
Connect the completed cable to your audio device.
11.
Plug the completed Euroblock connectors into the AV-P2 audio output jacks.
