19
Av-P2 O
utPut
M
Odule
u
ser
G
uide
The Euroblock plug, showing the screws that hold the individual wires in
place (left-to-right), hot (+), cold (-), and ground
Connecting to an Unbalanced Device
The AV‑P2 audio outputs can be connected to unbalanced audio devices;
connections can use single‑conductor or two‑conductor shielded cable.
Single-conductor shielded cable
To connect the AV‑P2 audio output to an unbalanced line‑level device using
single‑conductor shielded cable:
Strip the insulating jacket of the cable back about .75 inch
1.
(18 mm) to reveal the individual hot and ground wires
within.
Remove a small amount of each individual wire’s insulation
2.
(approximately .25 inch, 6 mm).
On the Euroblock plug, use a small screw driver to loosen
3.
and open the sockets that will receive the individual wires.
Insert the audio cable’s hot (+) wire into the matching
4.
socket on the Euroblock plug.
Insert the audio cable’s ground wire into the matching
5.
socket on the Euroblock plug. The cold (‑) socket on the
Euroblock remains unused in this configuration.
Tighten the screws on the wire sockets to secure the
6.
individual wires.
Plug the completed
7.
Euroblock plug into the desired output
channel on the AV‑P2.
Connect the completed cable to your audio device.
8.
