Avid Technology VENUE Local 16, Руководство по установке

Страница: 23 / 73

VENUE System Restore 19
3
Power on your E6L using the back panel power switch to the on (
1
) position, and then repeatedly press
F10
on the keyboard until
the “
Welcome to Avid’s VENUE System Restore USB Drive
” dialog appears on the monitor.
4
When prompted, press “r” (lower-case) on the keyboard.
5
When the Restore confirmation dialog appears, press Shift + R (upper-case) on your keyboard to proceed. Installation begins.
6
When prompted, press “A” (upper-case, Shift + A) on the keyboard, and repeatedly press F5 on the keyboard until the next
screen (Windows/RTX Activation dialog) appears on your monitor.
Important : On some system configurations the E6L engine will perform an additional reboot which may not be immediately ap-
parent. Because of this possibility, continue pressing F5 until the next screen appears on your VGA monitor.
7
If the VENUE software installer displays a message telling you that you need to update the BIOS, see
Updating the BIOS
.
Otherwise, proceed to
Activating Windows and RTX on E6L
.
Activating Windows and RTX on E6L
After installing VENUE software, activate the Windows operating system from Microsoft and the RTX64 real time processing en-
gine from Interval Zero. Windows and RTX64 are part of the VENUE software installation on your E6L engine, and must be ac-
tivated separately from VENUE software. To activate Windows and RTX64, the E6L engine must be physically connected to an
Internet source (Ethernet cable required; Wi-Fi not supported).
Activating Windows on E6L
To activate Windows and RTX64 on your E6L engine:
1
When the E6L restarts after installing new software and pressing F5, click
OK
to close the Windows/RTX Activation dialog
The system exits to the Desktop.
2
Click
OK
to dismiss the on-screen dialog stating “
The RTX64 Runtime is not licensed, or the license has expired.
”
The Windows Desktop appears.
3
In the Networks panel, click
No, do not share the network
.
E6L-192/144 engine power switch (E6L-112 has two power switches) and repeatedly pressing F10
Some models of USB keyboards require repeated pressing of F10 (holding it down in between pressings) to register.
If you forget to press F5 (or start pressing too late), the next screen will not appear on the monitor. If this occurs, power cycle
the E6L engine (power it off, wait until it completely shuts down, then power it back on again) and then press F5 repeatedly.
You must activate Windows and RTX64 immediately after installing the E6L System Restore software. The E6L engine will not
connect to the S6L control surface until you activate Windows and RTX64.
If the Desktop does not appear, press the WIN key (the key with the Windows logo), then click the Desktop tile to show the
Desktop.
The Networks panel only appears when a valid network is detected. If it does not appear, make sure your network is active.
IN
OUT
NETWORK
MASTER 1
WORD CLOCK
UTIL
EXPANSION
2
3
6
7
8
1
2
3
4
5
OK
OK
A B
AVB-192
ACT SIG ACT SIG
ACT SIG ACT SIG
A B
F10 F10 F10 F10
+ + + +