Avid Adrenaline Front and Rear Panel
7
The status LEDs are used during POST (see
) and light when the function specified by the LED is active. The
following table shows the name of each LED and describes its function.
Rear Panel
The following boards are attached to the Avid Adrenaline rear panel (see the
following figure):
•
Avid DNxcel (HD Video I/O) board
— Provides HD SDI I/O, HD
monitor, HD component, and a HD trilevel sync connections for video
equipment.
LED Functions
LED
Function
HD
Lit when high-definition codec is selected and POST
SD
Lit when standard-definition codec is selected and POST
DV
Lit when DV data is present on the 6-pin 1394 cable between the host
and the Adrenaline. These conditions are:
•
When capturing from a DV source
•
When capturing from an analog or SDI source, and DV is selected
in the Capture tool
•
When performing a Digital Cut with Digital Cut Native selected
NTSC
Lit when an NTSC project is selected
PAL
Lit when a PAL project is selected
REF
Blinks when a Reference signal is connected and constantly on when
the Avid Adrenaline is locked to the incoming Reference signal
Pull Down
Lit when Pull Down is selected in the application
LTC
Lit when LTC IN is being input to the Avid Adrenaline
44.1
Lit when 44.1-MHz audio is selected
48
Lit when 48-MHz audio is selected
96
Lit when 96-MHz audio is selected
Содержание Avid Adrenaline
Страница 54: ...Using the Avid Adrenaline 54...