Aviat Networks ECLIPSE EDGE, Руководство пользователя

Страница: 264 / 274

28 Aviat Networks
Chapter 3. Eclipse Edge Installation
If frequency and power settings are not correct, interference may
be caused to other links in the same geographical area.
Next Steps:
• Portal connection to Eclipse. Refer to
Setting Up Portal on page 7
.
• Eclipse configuration process. Refer to
Installation and Configuration Process
on page 25
.
• Eclipse antenna alignment. Refer to
Antenna Alignment for Edge on page 28
.
Antenna Alignment for Edge
This section includes:
•
Preparation for Antenna Alignment for Edge on page 28
•
Signal Strength Measurement for Edge on page 28
•
Aligning the Edge Antenna on page 30
•
Edge Main Beams and Side Lobes on page 33
Preparation for Antenna Alignment for Edge
Before aligning antennas ensure:
• The ODUspes are powered up at both ends of the link.
• Transmit and receive frequencies are correctly set.
• Transmit powers are correctly set and transmit mute is turned off.
NOTE:
If frequency and/or power settings are not correct for the
application, interference may be caused to other links in the same
geographical area. If in doubt, check link configuration as a priority
on initial power-on, and reconfigure as necessary.
Signal Strength Measurement for Edge
Two receive signal-strength indicators are provided to assist antenna alignment, RSL
in the Portal performance screen, and the RSSI voltage at the BNC connector on the
ODUspe.
Refer to:
• Using RSL Data
• Using the RSSI Voltage at the ODUspe