Avery Weigh-Tronix ZK830, Инструкция пользователя

Страница: 10 / 55

ZK830 Counting Scale User Instructions 11
2.3 Powering up the ZK830
2.2.1 Annunciators
The annunciators on the display are shown and labeled in Figure 2.2 .
Figure 2.2 Annunciators
The triangular annunciators will light during operation to inform the user of the weighing
mode, active unit of measure, etc.
2.3 Powering up the ZK830
The ZK830/BSQ comes with a base mounted AC power supply unit (PSU) connected
to the back of the BSQ. This supplies the required input power of 12 to 36 VDC @
200ma minimum and is connected to a properly grounded outlet (100 VAC - 240 VAC,
50 or 60 Hz). The indicator is always ON as long as power is received. See
Base
mounted AC PSU on page 13 .
If using the optional rechargeable battery pack mounted on the rear of the base you
can expect approximately 16 hours of operation between charges. Recharge time is
four hours using the in-line PSU. The battery pack requires 24 to 36V to charge. See
Battery power on page 14 for more information. The battery timer setting can be used
to turn the indicator display OFF automatically.
You can also power the indicator with a 12 to 36 VDC power supply (150ma minimum
at 24VDC) via a 2.1mm center positive barrel jack plugged into the receiver on the back
of the indicator.
The first time you power up the ZK830 you need to pick which application you will be
using. See
First time power up on page 16 for instructions on how to do this.
lb
kg
GROSS
NET
TARE
0
g
COUNT
HI RES
PRINT SP % PCWT TOTAL
Under Accept Over
Center-of-zero
Motion
Gross weight
Net weight
Tare weight
Print
High
Resolution
Battery
Status
Piece weight
Units of
measure
Total
Percent
Count
Active
Setpoint