Avery Weigh-Tronix WI-125 SST, Руководство по обслуживанию

Страница: 27 / 52

27
WI-125 SST Indicator Service Manual
Make sure you have the proper
amount of weight keyed in and
the proper amount of weight on
the scale when setting LIN-
EAR., or SPAN
1. When ZERO is displayed,
remove all weight from scale.
Wait till the scale is stable and
press
SELECT . . . BUSY is displayed briefly, then 0 .
2. Press SELECT . . . ZERO is displayed.
3. Press MENU . . . SPAN is displayed.
4. Set test weight on scale and let
the scale stabilize. Press
SELECT . . . A number is displayed.
5. Key in the amount of the test
weight on the scale and press
SELECT . . . Display shows BUSY briefly, then
the weight.
You may exit to the normal Weigh-
ing Mode by pressing
G/N , or
continue to Step 6...
You may stop calibration after setting ZERO and SPAN or continue on to set
LINEAR. if necessary for your application.
6. Press SELECT to return to the
SPAN display, then press MENU
to advance to the LINEAR
display.
7. Place approximately half the
span test weight on the scale.
Press
SELECT . . . A number is displayed.
8. Key in the weight now on the
scale and press SELECT . . . BUSY is displayed briefly and then
the weight. You may exit to the
normal Weighing Mode by pressing
G/N , or continue to Step 9...
9. Press MENU twice to advance to
DISPLAY .
10. Press SELECT to see the
displayed weight without exiting
the configuration menu.
You may exit to normal Weighing
Mode by pressing
G/N .
Use this mode to do a build-up
test or to check linearity.
Setting ZERO and SPAN
(Calibration)
Setting LINEAR.
Viewing DISPLAY