Avery Weigh-Tronix WI-125 SST, Руководство по обслуживанию

Страница: 10 / 52

10
WI-125 SST Indicator Service Manual
Dashes across the top of the
display indicate overload at
105% of capacity as a USA
standard.
Setup, Scale, Units-
Pounds, 1000g
Under each unit of measure you have the option of selecting ON or
OFF. Choosing the OFF option under a unit of measure disables
that unit of measure. If a unit is disabled, it will not appear in the
configuration menu under
CAPACITY or DIVISION nor will you be
able to choose it during weighing procedures.
Setup, Scale, Units, Capacity-
Pounds, 1000g
This menu section lets you set the scale capacity for those units of
measure enabled under
UNITS . This value equals the capacity plus
the overload tolerance.
Setup, Scale, Units, Capacity, Division-
Pounds, 1000g
This option lets you set the division size for the units of measure
enabled under
UNITS .
One feature not readily apparent is that the number of displayed
leading zeros can be specified. For example; for 10 pound divisions,
if you want 5 zeros displayed when no weight is on the scale, key in
00010 for a division size. The display will read 00000 when the scale
is empty. If you want two zeros displayed when the scale is empty,
key in a division size of 10.
Setup, Scale, Units, Capacity, Division, Zero-
-Percent, Percent
With this option you can set the plus and minus percent of capacity
the indicator can zero. For example, if the capacity of the scale is
10000 lb and the zero range is ±2%, key in 2 for both the positive
and negative ranges. You may key in decimal values.
Setup, Scale, Units, Capacity, Division, Zero, Stability-
Range, Delay
Range - This option lets you set the size of the motion detection
window in divisions. You may enter decimal values less than one or
up to 999999 which turns off the motion detection.
Delay - Use this to specify the number of seconds during which the
weight must be within range (described above) before a no-motion
condition is displayed. Default value is 0.4 seconds.
Setup, Scale, Units, Capacity, Division, Zero, Stability, A.Z.T.-
Range, Net
Range - With this option you can set the ± automatic zero tracking
window in scale divisions. To turn off AZT, enter a range of 0.
Net - If an AZT range is set, NET will appear in the menu. This
option lets you choose to enable AZT during net weighing opera-
tions (ON) or disable it (OFF). The gross weight must be zero for
AZT to work in net mode.