37736AA
16
Waterproof Cable Connector
This camera features an IP66-rated waterproof cable connector. For unprotected outdoor
connections, screw the connector on the included ethernet camera cable onto the camera dongle. If
your installation location does not require a waterproof connection, loosen and slide the connector
back on the cable until it’s out of the way.
Included Pieces:
Thread Lock Cap
Silicone Seal Ring
RJ45 Enclosure
Silicone “O” Ring
To Install the weather resistant cable connector:
1. Slide all pieces of the waterproof cable connector over the cable plug in this order:
•
Thread Lock Cap
•
Flexible silicone seal ring. You will need to stretch the silicone seal over the RJ-45 plug.
PRO TIP
:
Insert the flexible silicone seal ring onto the tip of a pair of needle nose pliers and stretch
the seal over the RJ45 plug.
•
RJ45 Enclosure
2. Stretch the small silicone “O” ring onto the camera dongle.
3. Connect the camera cable to the plug on the dongle. Screw the RJ45 Enclosure into the
dongle.
4. Insert the flexible silicone seal into the “crown” section of the large plastic ring.
5. Screw the small plastic ring into the large plastic ring.
PRO TIP:
To remove the RJ45 enclosure from the camera cable, tape down the locking tab on the
RJ45 plug with electrical or office tape.
NOTICE:
Do not attempt to disconnect the camera connection without loosening the smaller thread
lock cap. Forcing the assembly will break the camera dongle and void the camera
warranty.
