13
English
•
Daily, before use or when first putting the tool into service, pour a few drops of clean, light lubricating oil into the air inlet of the
tool if no lubricator is fitted on air supply. If the tool is in continuous use, the air hose should be disconnected from the main air
supply and the tool lubricated every two to three hours.
•
Check for air leaks. If damaged, hoses and couplings should be replaced.
•
If there is no filter on the pressure regulator, bleed the air line to clear it of accumulated dirt or water before connecting the air
hose to the tool. If there is a filter, drain it.
•
Check that the nose assembly is correct for the fastener to be placed.
•
Check that the stroke of the tool meets the minimum specification (page 5). The last step of the Priming Procedure on page 19
explains how to measure the stroke.
•
Either a stem collector or a stem deflector must be fitted to the tool if the vacuum extraction is ‘ON’. If it is turned ‘OFF’ a safety
cap must be fitted. See ‘side ejector’ opposite.
•
Check that base cover
40
is fully tightened onto body
38
.
•
Ensure that rotary valve
65
is correctly adjusted for fastener retention or turned off for Avtainer
®
and Maxlok
®
(see ‘Operating
Procedure’ page 7).
•
Dismantle and clean nose assembly, with special attention to the jaws. Lubricate with Moly Lithium grease EP 3753 before
assembling.
•
Check for air leaks.
Grease can be ordered as a single item, the part number is shown in the service kit page 15.
First Aid
SKIN:
As the grease is completely water resistant it is best removed with an approved emulsifying skin cleaner.
INGESTION:
Ensure the individual drinks 30ml Milk of Magnesia, preferably in a cup of milk.
EYES:
Irritant but not harmful. Irrigate with water and seek medical attention.
Fire
FLASH POINT: Above 220°C.
Not classified as flammable.
Suitable extinguishing media: CO
2
,
Halon or water spray if applied by an experienced operator.
Environment
Scrape up for burning or disposal on approved site.
Handling
Use barrier cream or oil resistant gloves
Storage
Away from heat and oxidising agent.
Item numbers in
bold
refer to the general assembly drawing and parts list on pages 18-19.
I M P O R T A N T
Read Safety Instructions on page 4.
The employer is responsible for ensuring that tool maintenance instructions are given to the appropriate personnel.
The operator should not be involved in maintenance or repair of the tool unless properly trained.
The tool shall be examined regularly for damage and malfunction.
Servicing the Tool
Daily
Weekly
Moly Lithium Grease EP 3753 Safety Data
Содержание Genesis G4 HD
