Avaya XBU48, Инструкция по установке и эксплуатации, Страница: 12 / 20

INSTALLATION
Avaya
t
XBU48 Site Preparation, Installation and Operator’s Manual
S
700071244 Issue 3
8
10. Verify that the circuit breaker on all XBU48s is in the OFF (O)
position (see Figure 4).
11. Plug the XBU48 battery output cord into the battery connector on
the UPS rear panel. All battery connectors are polarized to prevent
incorrect connection.
12. If additional XBU48s are to be used, plug the battery output cord of
the second cabinet into the battery connector of the first cabinet.
Follow this procedure for each additional XBU48.
13. Plug the detachable power cord into the charger AC input
receptacle.
14. Plug the other end of the power supply cord into a grounded,
three-wire, AC receptacle that has been wired in accordance with
NEC specifications or national wiring rules.
For 240V installations, use a NEMA 6-15P/IEC 320-C13, 6-ft,
detachable power supply cord that is UL-listed. Wire gauge should
be #16 AWG and the insulation type should be begin with SJ, SE, or
SO.
NOTE DO NOT plug the AC cord from the charger into any of the UPS receptacles.
NOTE The wall outlet must be within two meters of the equipment and accessible to the
operator.