Avaya S8700-Series, Установка и настройка

Страница: 59 / 122

Enabling the IPSI
Issue 8 May 2009 59
Enabling the IPSI
1. Type
change system-parameters ipserver-interface
and press Enter .
2. On a duplicated server, the system displays the following screen. Verify that the primary
control and the secondary control subnetwork addresses are correct.
The control subnetwork addresses typically match the most significant three octets of the
IP addresses of the server for the media gateway. The most significant three octets are the
first three groups of digits in the IP address. Select the
configure server
command on
the System Management Interface to see the IP address of the server.
An asterisk ( * ) to the right of the Control Subnet Address field means that
Communication Manager does not have the subnetwork information and the subnetwork
address displayed is incorrect.
3. If the information in the Primary Control Subnet Address field, the Secondary Control
Subnet Address field, or both fields is incorrect, use the System Management Interface to
change the server configuration to match the Server IP address in
configure server
.
Under Server Configuration and Upgrades, click Configure Server to change the server
configuration. Then return to this procedure.
4. Set the Switch Identifier field to the switch ID letter. Acceptable switch ID letters are A
through J. A is the default setting.
5. Set the IPSI Control of Port Networks field to enabled .
6. Press Enter to save the changes.
change system-parameters ipserver-interface Page 1 of 1
IP SERVER INTERFACE (IPSI) SYSTEM PARAMETERS
SERVER INFORMATION
Primary Control Subnet Address: 10.13.0.0
Secondary Control Subnet Address:
OPTIONS
Switch Identifier: init@svs8730-1-srv1>
IPSI Control of Port Networks: enabled
A-side IPSI Preference: enabled
IPSI Socket Sanity Timeout: 3
QoS PARAMETERS
802.1p: 6
DiffServ: 46