Avaya S8700-Series, Установка и настройка

Страница: 36 / 122

Chapter 3: Communication Manager installation
36 Installing and Configuring the Avaya S8500-Series Server
Applying power to the server
Note:
Note:
In this procedure, the software CD-ROM must be placed into the CD-ROM drive
on the server prior to or immediately after you turn on the power to the server.
1. Connect the AC power cord to server 1 and to UPS 1.
2. Press the Power button on the front of the server. Immediately place the Avaya
Communication Manager CD-ROM into the CD-ROM drive on the server.
Accessing the server
1. Use a cross-over cable to connect your laptop computer to the Services port on the back
of the server. The Services port is labeled
2
and is configured as Eth1.
2. At the command prompt window on your services laptop, type ping -t 192.11.13.6 and
press Enter .
The -t causes the ping to repeat continuously. When you get a response, in approximately
three minutes, wait an additional 30 seconds before you start a Telnet session to access
the information on the CD-ROM.
Configuring Telnet for Windows 2000 and Windows XP
The Microsoft Telnet application might be set to send a carriage return (CR) and a line feed (LF)
whenever you press
Enter . The Communication Manager installation program sees this as two
separate key presses. If you are running Windows 2000 or Windows XP, you must correct this
setting before you copy the Remaster Program to the hard disk drive.
1. Click Start > Run to open the Run dialog box.
2. Type
telnet
and press Enter to open a Microsoft Telnet session.
3. Type
unset crlf
and press Enter .
4. Type
display
and press Enter to verify that you see the message
Line feed mode -
Causes return key to send CR
.
5. Type q and press Enter to exit the telnet session.