Avaya S8700-Series, Установка и настройка

Страница: 57 / 122

Issue 8 May 2009 57
Chapter 5: IP interface translations
To administer IPSI circuit packs, use a terminal emulation program to issue Communication
Manager SAT commands.
For Communication Manager terminal emulation, use a program such as Avaya Native
Configuration Manager, Avaya Terminal Emulation, or HyperTerminal.
You also can use Avaya Site Administration to issue SAT commands. To administer some of the
features in the latest release of Communication Manager, you must use the latest version of
Avaya Site Administration.
Perform these tasks to administer IPSI circuit packs:
l
Inputting initial system translations on page 57
l
Adding media gateways on page 58
l
Enabling the IPSI on page 59
l
Adding the IPSI to the system on page 60
l
Enabling IPSI duplication (duplicated control network only) on page 61
l
Setting the alarm activation level on page 61
l
Saving translations on page 61
l
Verifying connectivity to the server on page 62
l
Verifying that the IPSIs are translated on page 62
l
Upgrading the IPSI firmware version (if necessary) on page 62
l
Enabling control of the IPSIs on page 63
l
Verifying the license status on page 63
Inputting initial system translations
1. Open a SAT session. See Accessing the SAT on page 103.
2. Enter translations:
If the system translations were prepared offsite, enter the translations and reset the server.
If the translations are not available, enter minimal translations to verify connectivity to the
port networks.
3. After you enter the translations, type
save translation
and press Enter to save the
translations to the hard disk drive.