AVANT STAGEV 860i, Руководство оператора

Страница: 76 / 148

Operating instructions Avant 860i
76
.
Ignition key
The ignition key can be switched into the
following positions:
1.
• (OFF) Shut down the loader engine

Ignition key can be removed
Most electric systems of the
loader are switched off.
However, some lights may not
be connected through the
ignition switch. To switch all
systems off, turn off the battery
main switch whenever leaving
the loader unattended.
2.
ON Engine run

The electric systems of the
loader can be used.
3.
Engine pre-heat

See starting procedure for
more information.

When released from this
position, the key switch will
return to ON.
4.
Starter run

Start the engine

When released from this
position, the switch will return
to ON.
.
To start the engine
1.
Perform daily checks (see page 106)
2.
Turn the battery disconnect
switch to ON.
3.
Sit on the driver's seat, adjust seat, and fasten
seat belt.
The loader will not start unless driver is seated.
4.
Leave hand throttle lever to
minimum position. See page
57.
5.
Make sure that auxiliary hydraulics is switched off
(lever is released to its neutral position), see page
55
Do not press on the drive pedals.
6.
Turn the ignition key to the right, to ON position.
The multi-function display will switch on. Signal
lamps on the dashboard will light up briefly for
self-check. You don't need to wait until the display
has switched fully on.
7.
Turn the ignition key further to the right until the
engine starts. Return the key to position ON
immediately when the engine runs.
The ECU will control the intake air heater
automatically depending on ambient temperature.
The display may reset and start again during the
start.
Do not actuate the starter for more
than 10 seconds at a time. If the
engine does not start, wait for one
minute before repeating attempt. If
the engine does not start after a
few attempts, or runs poorly, see
troubleshoot on page 138 and the
engine owner’s manual.