14
STEP 7: Electrical circuit
1. Connect the cable
i
(without filtration) detection plug, in the electrical box
D
present on your pool.
This cable must be connected to an
auxiliary contact
of the filtration starter contact. The voltage will be
230V on the cable terminals
when the filtration pump is on. In this way, the POOLeasy unit will be
authorised to dose.
2. Connect the power-supply cable equipped with its plug, in a domestic power-supply socket. It is
preferable that the 230VAC supply originate from your pool's electrical box
D
, just after the general circuit-
breaker.
STEP 8: Connect the sensor to the corresponding terminal on the instrument
D
i
A
Plug the plug into the bayonet
socket
Rotate the plug ¼ turn to close the
connection
Содержание POOLeasy pH
