AuviTran AVM500-ES, Руководство пользователя

Страница: 45 / 52

Serial port Interpreter
Now, in Port A control page, select “Serial Port” in “Egress Port for Tunneling” combo box. And finaly, turn-on interpreter by
checking “Serial Port Remote Ctrl” check-box. That’s it! Don’t forget to use a crossed RS232 cable between AVM500-ES and
your remote control device.
10.2 System architecture and conventions
The AuviTran AVM500-ES has 5xES100 ports named A, B, C, D and E. An AVM500-ES Port has 64 inputs and 64 outputs.
By convention, an inputs or an outputs of a port P is directly named by as simple basic letter {A, B, C, D, E} following by a 2
decimal digits. For instance:
ƒ A01 is interpreted as I/O 1 of port A
ƒ E62 is interpreted as I/O 62 of port E…
10.3 Programming interface
Any serial command is defined by a set of ASCII char following by <CR> or <CR><LF> ASCII sequence.
Five commands are defined today from the serial port patch:
•
Get serial protocol version
•
Set output patch
•
Mute output
•
UnMute output
•
Get output information
If an unknown command is sent, interpreter will return the ten first characters of the command, followed by « ? » character.
At end of each response, prompt character “>” is added after <CR>.
10.3.1 Get serial protocol version
Syntax:
V? <CR>
Answer:
V=X.Y <CR> >
Where X.Y is the version number of the serial protocol.
For instance:
Command send: V?
Answer received: V=1.0
AVM500-ES User’s Manual v2.1 AuviTran 2010 45