AUTOTERM PLANAR-2D-12/24, Руководство по установке

Страница: 26 / 29

26
3.9.9 Modem Installation
GSM modem (Fig.30), which in essence is an analog
of cell phone without display and keyboard, is designed for
use in harsh environments (cold, vibration, etc.). The
modem, same as a cell phone, has a SIM card installed, i.e.
the heater acquires a full telephone number of your chosen
service provider. The modem can be installed in any
convenient, clean place. For more details about the modem
see Instructions to the modem.
4 Checking the Heater after Installation
After installation of the heater it is necessary to check that
all wires, clamps and electric connectors established and fixed
well. Fill the fuel-supply line completely and remove the air
from it.
The fuel-supply line can be filled in two ways:
1) to start a heater several times. Time of one full
start - 5 minutes.
2) to use the fuel pumping device*
Control of filling of the fuel-supply line is exercised
visually, through transparent tubes of a fuel-supply line.
Connect of a heater to the electrical supply and install fuses
on a harness of a heater.
During the first start it is necessary to check tightness of all
connectors and durability of their fastening. If necessary,
tighten the clamps.
At the first start perhaps small smoking from an exhaust
pipe.
5 Recommendations .
If the heater does not start after switching on, make sure
there is fuel in the tank, check the charge of the battery, check if
connectors are properly connected and if the 25A fuses are good.
If you are unable to determine the cause of the fault, please
contact your local dealer, or visit www.autoterm.ru.
* - optional.