AUTOTERM PLANAR-2D-12/24, Руководство по установке

Страница: 9 / 29

9
3 Installation .
Observe safety requirements during heater
installation.
3.1 Mounting Location
The heater can be mounted both inside and outside the
vehicle.
For outside mounting the heater should be installed in
an area protected from water and dirt. The heater should be
mounted in such a way that it is not exposed to water at
overcoming water obstacles by the vehicle.
Heater dimensions are shown in Figures 5-8.
3.2 Heater Installation
Mounting positions should be in accordance with
those shown in Fig.9-12. The intake of the heater should be
positioned in such a way that, under normal operating
conditions, exhaust gases of the engine or of the heater could
not be sucked into it.
During installation and operation of the heater, intake
and outlet of the heater should be protected against foreign
objects getting into them.
When installing the air ducts to the heater, they should
not have deformations, reducing the flow area of the duct.
The maximum length of the output duct should not exceed
5 meters in total.
When mounting the heater, care should be taken
to ensure that its housing does not have harmful
contact with projecting parts of the floor or other
parts of the cabin.
Installation of air ducts to the air heater
PLANAR-8DM is forbidden
3.3 Mounting Holes.
For heaters PLANAR-2D, PLANAR-4DM2 and
PLANAR-44D, holes in the body of the vehicle should be
made as shown in Fig.12. Heater can be installed using
mounting brackets, see Fig.11 (in that case, longer studs should
be installed in the heater).
For heaters PLANAR-8DM, holes in the body of the
vehicle (with the thickness of the body (floor) of not more than
3mm) should be made as shown in Fig.12.
With the thickness of the vehicle body (floor) of more
than 3мм, installation of the heater requires the following:
1. To make a hole in the form of a rectangle with sides of
180 x 95 mm in the body of the vehicle;
2. To attach a mounting bracket to the heater (this bracket
can be made of steel sheet at least 2.5mm thick, see Fig.12);
3. To attach the exhaust pipe, air intake, and fuel line to
the heater and fasten the whole assembly to the body of
the vehicle