AUTOTERM PLANAR-2D-12/24, Руководство по установке

Страница: 25 / 29

25
3.9.7 Controller Installation
Controller is mounted in any place convenient for the
driver (personnel). The Controller is mounted by means
either of double-sided tape or a bracket:
- double-sided tape, attached to the rear surface of
the Controller. The connecting wire can be led out of the
Controller housing through the back cover, or through the
side surface of the housing, by removing the partition.
Before installing the Controller, first degrease the
installation surface, then remove protective film from the
adhesive tape, and attach the Controller to the prepared
surface.
- bracket (Fig.28), fastened to the panel with screws.
The wire is led out of the Controller housing through the
back cover. The Controller snaps to the bracket with an
audible click.
3.9.8 Cab Sensor Installation
Cabin sensor (Fig.29) is designed to measure air
temperature in the area of its installation, which allows to
maintain there the desired temperature. The maximum length
of the cabin sensor cable is 5000mm. The sensor is mounted in
a convenient for the driver (personnel) place. The temperature
sensor should be installed at medium height on the vertical
surface in a heated area.
The temperature sensor should not:

Be located directly in the stream of heated air (from
the vehicle heating system or the heater itself);

Be close to heat sources;

Be exposed to direct sunlight

Be covered with cloth or the like