In
st
al
la
tio
n
an
d
S
pe
ci
fic
at
io
ns
2--8
Installation and Specifications
5 VDC
(+)
Insert power supply connector
into receptacle
OP-PS400
Power Supply
0 VDC
(--)
Serial Port Receptacle
Connecting the Configuration Cable
You will need two cables to use your OP-panel: A configuration cable (part number
OP--CCBL) and a communications cable. Connect the configuration cable between
the serial port on the rear of the OP-panel and the serial port of the personal
computer. The panel may then be configured using the OP--WINEDIT configuration
software. The figure below shows configuration cable connectors and wiring
specifications. The wiring diagram refers to the cable connectors,
not
the
communication ports. This cable is disconnected after configuration.
OP--CCBL Configuration Cable
Computer
Panel
1= not used
2= RX
3= TX
4= not used
5= Sig ground
6= not used
7= not used
8= not used
9= not used
9
5 VDC Power Supply
3 4 5 6
2
1
1= Sig ground
2= Cfg mode
3= RX
4= TX
5= not used
6= Sig ground
RJ12
DB9
RJ12
5
4
2
3
3
2
1
5
6
DB9
1
(Sockets)
Power Supply
Connections
Configuration
Cable
