DPM3 User Manual, 1st Edition
User Manual - DPM3 Series Panel Meters
13
present
(Anout)
, logic functions configuration
(LoGIn)
. Press
ENTER
to access the submenus
under each main menu.
If configuration has been totally locked-out, when pressing
ENTER
to access the main menu
level, the display shows
dAtA
instead of
Pro
. This indicates that it is only possible to see
programmed information and that it is not allowed to modify any parameter from the entire
configuration. In this visualization mode, the meter automatically switches back to
RUN
mode
after 15 seconds sine the last key press.
-
1
Input
Menu
2
3
4
5
Display
Menu
Relay
Configuration
Menu
Analog
Output
Menu
Logic
Functions
Menu
ENTER:
Vertical displacement.
UP:
Changes active digit.
SHIFT:
Horizontal displacement.
Programming Key Pad
The progress through the programming routines is done by pressing
ENTER
key. In general,
push
SHIFT
key a certain number of times to select an option and push
ENTER
key to validate
the change and move forward to the next step of the program.
Programming numerical values
When the parameter is a numerical value, the display will show the first of the digit to be
programmed blinking.
Digit selecting:
Press repeatedly the
SHIFT
key to shift from left to right over all the display
digits.
Changing the digit value:
Press repeatedly the
UP
key to increase the value of blinking digit
until it has the desired value.
The minus sign is programmed depending on the variable type. A variable that represents the
value of an input will be able to take a value in the range -19999 to 99999, without taking into
account the decimal point. When a digit is selected it shows values from (0) to (9), and then
(-1), (-), and comes back to show values from 0 to 9. A variable that represents a display value
will be able to take a value in the range -19999 to 39999, without taking into account the
decimal point. In these case the first digit shows 0, 1, -1, 2, 3 or -.
Completion of each submenu routine returns the meter to
Pro
mode. To save data entered or
changed during configuration press the
ENTER
key while in
Pro
mode.
StorE
will be displayed
for a few seconds while all of the configuration data is stored in memory. The meter will then
return to
RUN
mode.
