Automatic Technology SECURALIFT, Инструкция по установке и руководство пользователя

Страница: 9 / 19

STEP 9
Determine the centre of the door and mark this
location on the wall above and on top of the
door. Then draw two (2) lines 21.5mm on each
side of the door. (Fig. 9)
STEP 10
Raise the door to open position. Reset the
opener on the top edge of the door with end of
the pipe/tube against the header wall and drive
unit support in level with the lowest point of
the open door. (FIG. 10)
Note: Do not slide opener tube/pipe on face of
the door when it is open.
Attach the angle (not supplied) to the ceiling
and connect angle and drive unit with two (2)
flat perforated strips of the angle (not supplied)
with M8 x 20mm screws and nuts. Strips
should not extended more than 18mm below
centre of the mounting holes of the drive unit.
A representative mounting is shown. (FIG. 8 &
8a) Do not lock screws at this stage.
STEP 11
Close the door slowly. The opener pipe/tube
will be elevated by the top edge of the door as
it moves. Stop the door when it is at its highest
point of travel. (FIG. 11)
Allow 25mm additional height for clearance
between the door and the track. Support pipe /
tube in this position and the close the door.
(FIG. 11) This will be the height to mount the
wall bracket. Top of door must not touch tube.
MOUNTING OPENER–
ONE PIECE DOOR WITHOUT TRACK
9
WARNING; MAKE SURE CONCRETE, BRICK
WALL OR TIMBER LINTELS ARE SOLID AND
SOUND SO AS TO FORM A SECURE MOUNT-
ING PLATFORM.
WARNING: THE OPENER MUST BE SECURELY
FASTENED TO A STRUCTURAL SUPPORT OF
THE GARAGE. FAILURE TO FASTEN THE OP-
ERATOR CORRECTLY WILL LEAD TO POSSI-
BLE OPERATOR FAILURE CAUSING SERIOUS
INJURY TO PERSONS/ AND OR PROPERTY.
CENTER OF DOOR
FIG. 9
STEP LADDER
FIG. 11
STEP LADDER
25mm
DOOR
TUBE
HIGHEST POINT
OF DOOR TRAVEL
FIG. 10