Automatic Technology SECURALIFT, Инструкция по установке и руководство пользователя

Страница: 13 / 19

16.5 CLOSE SAFETY OBSTRUCTION TEST .
The door now must be tested for response to an obstruction while it is opening and closing. Press the yellow button
with the door in the open position, the door should start closing. When the door reaches half the closing distance
hold the bottom of the door with your hands. If the door does not reverse open easily the force may be excessive and
need adjusting.
IMPORTANT : If the door is unable to reverse when obstructed discontinue use. Do not use the door with a
inoperative obstruction sensing. Repair fault and test before using.
STEP 17
SETTING TRANSMITTERS
CODES INTO DOOR OPENER
The Remote Transmitters and Wall Mount Trans-
mitters can be programmed into the Door Opener
as below. Make sure to connect the battery to the
Transmitter. The memory in the Openers receiver
can store up to 27 different remote control trans-
mitters
.
STEP 17.1 STORING THE TRANSMITTERS
CODE
1. Press and hold the blue Door Code button
on the Control Panel button 2. (FIG. 17)
2. Press the button (one of four) on the Trans-
mitter you would like to use to control the
door
for approximately two seconds, (FIG. 17)
Pause for two seconds. Press the same button
again on the Transmitter for approximately
two seconds.
3. Release the blue Door Code button 2.
4. Press the Transmitter button to see if it operates
the door. If you wish you can code in all four
buttons on the Transmitter so all four can
operate the same door
17.2 STORING ADDITIONAL TRANSMIT-
TER (S) FROM A REMOTE LOCATION
Using this method you don’t need to have access to
the control panel on the Door Opener. However,
you do need a transmitter that is pre coded to the
controller’s receiver.
IMPORTANT NOTE: The Door must be acti-
vated when the steps below are preformed. The
moving Door is to confirm from a remote loca-
tion that the correct button was pressed and the
transmitter is in range of the opener of a pre
coded Transmitter.
1. Take any pre coded Transmitter. Press the
button for the function you require until the
door is activated and release.
2. Then using a small paper clip press and hold
firmly for 2 seconds through the
Coding Hole
(FIG. 18)
3. Within 10 seconds take the additional trans
mitter you wish to code and follow
STEP 17.1
para 2, as above
IMPORTANT NOTICE : PLEASE EXTEND ANTENNA
TO ITS MAXIMUM LENGTH.DO NOT LEAVE
COILED.DO NOT CUT ANTENNA WIRE. AND KEEP IT
FROM TOUCHING ANY METAL. IF THIS NOTICE IS
NOT FOLLOWED RANGE WILL BE REDUCED.
13
FIG. 17
FIG. 18