The informat ion conta ined in th is docu ment is the property of Automat ic Syst ems and is conf ident ial. The rec ip ient is forb idd en to use it for any purpose ot her
than for the use of the products or the exe cut ion of the project to wh ich th ey refer or to communicate it to th ird parties w ithout the pr ior wr itten conse nt of
Automat ic Systems. Document sub ject to change w ithout advance not if icat ion .
SL93x + TBV327-MT-EN
p. 22/40
5.6. Adjusting the obstacle closed point
1. Close and lock the obstacle.
2. Loosen the 6 bolts (D) on the conical coupling (4, p6) for 3
mm.
3. Tighten the 3 bolts (E) in the upper ring so that the 2 parts
of the coupling are separated.
4. Move the obstacle to its closed position.
5. Unscrew the 3 bolts (E) and tighten the other 6 (D).
5.7. Setting the movement limit stops (5, p6)
Note
:
there are no stops for the TBV327turnstile!
Note
: Check that the obstacle operating angle allowed by the stops is greater than the angle
set by the "60°/90°/rotating", "opening angle clockwise" and "opening angle anti-clockwise"
parameters (p 27).
1. Loosen screw (
41
) on cams (
40
) and (
43
).
2. Switch off the power 10 s and turn it back on.
3. Give a sustained opening command: for the 1
st
opening command after a power on, the
obstacle stops at the selected opening angle.
Bring cam (
40
) against stop (
42
), then position the cam 3 mm back from the stop. Tighten
screw (
41
).
4. Release the opening command: the obstacle close s.
5. Give a sustained opening command: the obstacle opens and remains at low speed against
the limit stop (provided the stop is not more than 20° from the selected opening angle .
6. Adjust the second cam (
43
) in the same way for the other opening direction.
D
E
40
41
43
42
