Installation Manual
–
200E Series
Page 11
Other Interfaces
Ethernet MODBUS/TCP
The DCU connects to a LAN (Local
Area Network) or directly to a PC
through a standard CAT-5 network
cable connected to the RJ45 port.
The IP address in the DCU and/or the
local PC may need to be changed in
order to access the DCU configuration
from a PC.
Note! Do not bend the Ethernet cable
or pull the cable sideways more than
necessary during installation.
Use a strain relief for the cable making
the cable length no more than 50 cm
between the connector and the strain
relief.
USB Memory Interface
This interface is used for two
purposes:
Update of the current
configuration file (not RP
panels).
Update the panel firmware (all
panels)
Copy a valid configuration and/or
firmware file to a USB memory stick,
and insert the USB memory stick in the
panel.
Follow the instructions that will be
appearing on the screen.
First Power-On
Preparations
First, make sure to consult the Quick
Installation Guide (QIG) that came with
the panel.
Installation
Install the panel according to
guidelines in the QIG.
Connections
Connect power to the panel according
to guidelines in the QIG.
First Power-On Wizard
The DCU (not DCU 208E) will display
the
first power-on wizard
at the first
power up after delivery, or after a
factory reset of the panel.
All wizard settings can be changed
later.
