Installation Manual
–
200E Series
Page 5
Panel Cut -out
The DCU and RP cut-out size is:
153mm width, 123 mm height
Mounting bracket
DCU 210E and RP 210E/220E
When installing the panel make sure to
use the bundled screws and mounting
bracket.
If installing the panel on a thicker
surface than 5mm, longer flanged
screws must be used. In this case M3
16mm flanged screws is
recommended.
Make sure that the screws are not too
long, as this will damage the panel.
The DCU 210E / RP 210E installed with the
mounting bracket shown in grey.
Connectors
DCU 210E, DCU 208E, RP 210E
and RP 220E
These are the connectors on the DCU
and RP back lid.
The DCU 208E front view is the same as the
DCU 210E rear view.
Connector kit
The 200E series is not shipped with
mating connectors.
A complete kit is available containing
all of the mating terminal blocks used
on the 200 E series.
Kit 1006479 contains:
4 Deutsch DT series connectors
(DT06-12SA).
50 hand crimp sockets 0.5 -1.0
mm
2
(16-20 AWG).
10 hand crimp sockets 1.0 -2.0
mm
2
(14-16 AWG).
50 sealing plugs for unused
terminals.
A crimp tool is necessary for
proper crimping of the mating
terminals. Use Deutsch HDT-48-00
crimping tool.
