18
Device number check
This check is necessary to confirm the connection
between the plastic card with codes and the installed
device. If the open Serial number on the card does
not match with the device, the only way to change
the forgotten PIN-code for the new one will only be
possible in a specialized service centre.
It is recommended to do this check right after one gets
the car with the installed anti-theft system IGLA from
the service centre.
1.
Switch ON the ignition without starting the engine.
2.
Press the brake pedal and while keeping it pressed
press the accelerator* pedal a certain number of
times as far as it can go where the number is equal
to the first figure in the Serial number (indicated on
the plastic card). Release the brake pedal. The first
figure of the Serial number will be entered.
3.
Input all the rest figures of the Serial number in the
same way (see item 2).
If the
Serial number matches with IGLA, the system will
signal with 2 flashes. If nothing happens, that means
the number was entered incorrectly or it does not
match with the installed device number.
Change of PIN-code
The PIN-code set in the service centre shall be changed
when the car-owner get his/her car back from the
service centre with the anti-theft system IGLA installed.
* For some car model other controls are used instead of an accelerator pedal
(see the annex).
Содержание IGLA
Страница 1: ...OPERATING MANUAL ...
Страница 25: ...25 Author Config ...
Страница 51: ......
Страница 52: ...Supported Cars List App ...