AUTHOR Alarm IGLA, Руководство по эксплуатации

Страница: 33 / 52

33
1. Make sure the key fob can be used for automatic
connection with the device:
• insert the battery in the key fob;
• make sure the LED is flashing with green light.
2. Take out the batteries from all key fobs including
those connected to the system and switch OFF
Bluetooth on all smartphones.
3. Switch ON key fob connection mode:
• Switch ON the ignition without starting the
engine.
• Authorize in the system via PIN-code
• Press the accelerator pedal as far as it can go and
keep it pressed*
• Enter the PIN-code again
• Release the accelerator pedal when indication
signal will start flashing every 3 seconds
• Press the Service button** 2 times
During connection procedure the key fob
interaction radius is limited. For successful pairing
it is recommended to put the key fob as close to
IGLA system as possible (1 meter or closer).
4. Insert the battery into the new key fob. The LED on
key fob will start flashing continuously with green
light. After the successful connection the LED will
blink once with red light.
If the connection did not happen, the green blinking
stops in 30 seconds after inserting the battery.
Be sure to check the key fob operation after connection
it to the device.
* For some car model other controls are used instead of an accelerator pedal.
** See the annex.
!