PLACA DIRECTORIO
– DIGITAL PANEL DIRECTORY
8
Funcionamiento
-
Functioning
P E D R O
N
O R
E
P
L
Y
P E D R O
L I N E E N G A G E D
P E D R O
< < C A L L I N G > >
P E D R O
< T A L K I N G >
•
At the end of the conversation, the system will make a beep and will return to the main screens 1,
2 and 3.
CALL TO A FLAT USING THE NAVIGATION ARROWS (
Å
y
Æ
):
•
It is also possible to perform the calls from the panel, searching through the names stored in the
data base of the Directory panel, with the left and the right arrows. Each time an arrow is pressed
the system will show screens displaying some data of the neighbours in the building (the
Name
,
some
Flat Information
and the corresponding
Call Code
). When the desired name is reached, the
OK
button
or the
key should be pressed. See the following example:
A N T O N I O L O P E Z
1 º P t a 2 6 3 0 1 9 9
•
The display messages will be the same as if we had called entering a ‘
Call Code
’.
•
If the Data Base contained marked registers, when any arrow (or OK) is pressed, the following
screen is shown:
P r e s s 1 o r 3 f o r
q u i c k s e a r c h
•
At this point it is possible to go forward or backwards among the existing marks pressing
1
and
3
,
or just navigate register by register with the arrows (
Å
,
Æ
). Remember that if any arrow key is
kept pressed during a pair of seconds, the navigation will go faster.
The Installer
•
A pair of programming codes will be provided to the Installer in order to give him access to two
different menus: The
Configuration Menu
& The
Directory Menu
.
•
By default, the code to enter to the Configuration Menu is ‘
1’
, and the code to get access to the
Directory Menu is
‘9’
. To Enter these codes we should first press
C, and then
(C+
should
not be pressed at the same time).
A line (“
---------
“) will appear asking for these codes. We can
change these codes later in the Configuration Menu to any number up to 9 digits (
this is strongly
recommended
).
Press
Å
,
Æ
or OK.
The Name,
Flan Info, and the Call Code are
shown on the display.
Press
.
The code exists in the
DB and the monitor is available
The neighbour in the flat or the
guard porter leaves the handset up.
Pulsar
.
The panel is external
and the SDL does not answer.
Pulsar
.
The system is busy by
another panel or by the
Switchboard.
Press
Å
,
Æ
or OK.
Instructions to
perform a quick search.
