Austria Email KRO, Инструкция по эксплуатации

Страница: 6 / 13

6
WATER CONNECTION
The water heater is suitable for pressure-free assembly. The system allows for water
withdrawal at a tap. The connection is to be done in accordance with the valid standards
and laws as well as according to these operating and assembly instructions, including the
corresponding diagrams.
For a pressure-free mounting, a corresponding mixed tap is required, which must be
coordinated to the type of assembly (under table or over table).
The cold water connection is marked in blue and the hot water connection is red. A non-
return valve must be installed on the inlet pipe before the mixed tap, which prevents the
water draining from the boiler if there is no water in the system. If the system line pressure
is higher than 5 bars, a pressure reducing valve must be installed before the mixed tap.
When choosing the mixed tap, the manufacturer's specifications with respect to a pressure
drop from the resistor are to be observed, which results with the flow of the water through
the mixed tap. When the valve is fully open, this pressure may not be higher than 0.2 bar.
No devices with a water drive or water diffuser may be connected at the water outlet, which
could cause a pressure increase in the boiler. If the instructions are not complied with,
damage may occur during start-up. These are excluded from the warranty and guarantee.
Above the sink Below the sink
Legend:
1 - Shut-off valve
2 - Reducing valve
3 - Return Flow Inhibitor
4 - The single hole mixed tap - on top
4a - The single hole mixed tap - below
H - Cold water
T - Hot water