DEMO XTR-8LR100
DEMO XTR-8LR10
User Manual
Le caratteristiche tecniche possono subire variazioni senza preavviso. AUR°EL S.p.A. non si assume la responsabilità di danni causati dall’uso improprio del dispositivo.
AUR°EL S.p.A. Via Foro dei Tigli, 4 - 47015 Modigliana (FC) – ITALY
Tel.: +39.0546.941124 Fax: +39.0546.941660
http://www.aurelwireless.com
- email:
Rev 2.2 17/05/2016
Page
16
of
17
From sleep mode unit 2, send the following commands:
Command from
PC
→
DEMO XTR-
8LR100
Answer from
DEMO XTR-8LR100
→
PC
Description
++++
COMMAND-MODE
Input in Command mode
ATS20=5000
OK
Set the cyclic restart time of the
transmitter every 5 seconds
ATS10=1
OK
It activates network mode
ATS12=0002
OK
Insert the address source address = 2
ATWR
OK
EXIT
It saves the new settings on Eprom and
exits from command mode.
Close the jumper SET_B and leave open jumper SET_A e SET_C, set the speed of the serial port of
Realterm to 115200bps.
LD2 is on.
The unit 2 is configured in cyclic transmission, waiting for Realterm sends a string of characters.
Unit 1 is in receipt cyclic completely off with consumption of 1uA for 5 seconds and on for a short time to
search a valid preamble.
When the unit first is in reception, intercepts a valid preamble, switches on LD1 and stays on until the
forwarding of the message to Realterm
Screens displayed by Realterm for unit 1 (RX cyclic) and unit 2 (TX cyclic):
Unit 1 port 57 receives from unit 2
\x0 \x2 TX CICLICO
Unit 2 port 58 sends to unit 1 the message
\x0 \x1 TX CICLICO
