26
In extreme situations (such as crashing of the controller), the RESET
function can be used. The
RESET
button is located under the flap covering
the outlet terminals.
RESET
0
I
A
B
C
D
This function enables restoring the factory settings. In order to use it,
press the "
+
" button, the "
OK
" button, and the "
-
" button simultaneously
for 5 seconds.
8
RESET
9
MASTER RESET
10
Technical data
Temperature settings range:
10 ÷ 85
Range of measured values:
0 ÷ 99
Hysteresis (start stop
)
f
2 10
Supply voltage:
230V / 50Hz
Maximum load for output sum:
6A
°C
°C
°C
°C
/
diff.
rom °C to
°C
A. Data pertaining to the controller working in a CH circuit
Temperature settings range:
10 ÷ 85
Range of measured values:
0 ÷ 99
Hysteresis (start stop
)
f
2 10
Supply voltage:
230V / 50Hz
Maximum load for output sum:
6A
°C
°C
°C
°C
/
diff.
rom °C to
°C
B. Data pertaining to the controller working with a CH pump and
valve "Z" (or with a second CH pump in a fireplace boiler stove circuit)
a tee
27
Temperature settings range:
10 ÷ 85
Range of measured values:
0 ÷ 99
Hysteresis (start stop
)
f
2 10
Supply voltage:
230V / 50Hz
Maximum load for output sum:
6A
°C
°C
°C
°C
/
diff.
rom °C to
°C
C. Data pertaining to the controller working with a
hot domestic water (HDW) pump
Temperature settings range:
10 ÷ 85
Range of measured values:
0 ÷ 99
Hysteresis (start stop
)
f
2 10
Supply voltage:
230V / 50Hz
Maximum load for output sum:
6A
time of the
°C
°C
°C
°C
/
diff.
rom °C to
°C
NOTE: The maximum load in the "D" section is 1 A (230 W / AC switch)!
Blow-through time and
0 - 59 sec. and
interval between blow-throughs:
1 - 99 min.
D. Data pertaining to the controller working with a fan
Cleaning and maintenance
ź
The outside of the controller must be cleaned with a clean cloth. Do not use
solvents (such as benzene, thinners, or alcohol).
ź
Do not touch the device with wet hands. This can lead to electric shock or
serious damage to the device.
ź
No not expose the device to excessive impact of smoke or dust.
ź
Do not touch the display with sharp objects.
ź
Avoid contact of the device with liquids and moisture.
Disposing of the devices
The devices are marked with the crossed waste bin symbol.
According to European Directive no. 2002/96/EU and the Act
concerning used up electric and electronic equipment, such
a marking indicates that this equipment may not be placed with
other household generated waste.
The user is responsible for delivering the devices to a reception
point for used-up electric and electronic equipment.
Содержание S14
Страница 1: ...User manual www auraton pl S14 dla oprogramowania w ver F03 oraz F0A ...
Страница 28: ...www auraton pl ...
