26
Start tracking the target altitude line:
When the camera is target-free (at bit 0), the
detected target head must be higher than the
line before camera tracking can be triggered.
In order to avoid untracked targets (such as
sitting students) triggering tracking by mistake
5.Set other parameters, default values are
recommended.
Tilt Motion: when it’s enabled, the camera will
automatically adjust tilt angle during tracking.
When it’s disabled, the camera will track as
per the tilt angle of preset 1.
If the lecturer does not walk into the student
area, it’s suggested to
disable tilt motion.
Tracking Parameters
Track Sens: set sensitivity of tracking based
on speed of movement. High sensitivity will
track at small movement.
Track Speed: set pan speed for tracking;
Lost Timeout: set the interval before Object
lost action will be performed, (go to preset 1 or
0). Default is 5 seconds.
Power On State: the action to be performed
when the camera is powered on.
6. complete setup, start tracking
Start: turn on tracking, using controller or
software to call preset 80 can also turn on
tracking.
Settings: click this button to get into detailed
tracking parameters for configuration.
Содержание JECTOR
Страница 27: ...22 Preview Click Main View to get into camera control and preview part as below...
Страница 29: ...24...
Страница 34: ...29 ANNEX 2 SIZE AND DIMENSION Front Top Rear Side Bottom...