COMfortel 1400 IP/2600 IP/3600 IP - Firmware V2.6 - Operation/Configuration - V05 09/2016
44
Commissioning
Overview of the Commissioning
Note:
If you require a longer or shorter network cable, use one without
snap tab protection. Otherwise, you may not be able to insert it far
enough.
•
For operation of a COMfortel 3600 IP with Power over Ethernet (PoE):
Bridge plug inserted into the power supply socket.
•
For operation of a COMfortel 3600 IP with wall wart(s): wall wart(s)
connected to the telephone
•
For operation of a COMfortel 2600 IP without PoE support: An
additional network cable and an PoE Injector as adapter between the
power socket and the Ethernet cable
•
For operation as system telephone: PBX according to the proper use
(see Important Information > Proper Use)
•
Internal telephone number entered during configuration with the corre-
sponding password of the telephone
•
For automated configuration from a provisioning server: provisioning file
which is stored on the provisioning server and is known on the DHCP
server
1. Insert one cable end of the network cable into the PoE socket at the
bottom side of the telephone.
2. Insert the other cable end of the network cable into an output socket of
the DSL router/switch or into an available network socket.
Note:
To operate a COMfortel 2600 IP without PoE support, insert the
other cable end of the network cable into the PoE socket of the PoE
Injector and connect the PoE Injector to the network via the LAN socket.
3. If required, insert the wall wart(s) and PoE Injector into a power socket.