Audionet PRE G2, Руководство пользователя

Страница: 13 / 39

13
6 Usage
All functions of the PRE G2 are microprocessor controlled. This guaran-
tees highest precision, exclusive functions, easy handling and protection
against operating error.
6.1 Powering up
First of all, please make sure your PRE G2 is connected correctly to your
signal sources, power amplifier(s) and mains (see section
'Installation
and power supply ' on page 9 and ' Inputs and outputs ' on page 11). The
PRE G2 is a stand-by unit. Please operate the mains switch 12 on the
back panel. The display shows for a brief moment a welcome message.
After that the PRE G2 is in stand-by mode. The display will indicate the
stand-by mode with either the text
off
or with a small dot (pixel) in the
display (see section ' Set Off-Text ' on page 25).
Only in cases of extended absence (like vacations) or if massive trouble
on the mains power is to be expected it is recommended to disconnect the
PRE G2 from mains. Operate the mains switch 14 on the back panel of
the unit to switch off the unit from mains. The display will go dark.
Important
·
Before you switch off the PRE G2 from mains, power down and
discharge completely all units connected to the outputs of the
PRE G2.
6.2 Switching on and off
To power up the PRE G2 from stand-by mode, press the power key on
the front panel. The PRE G2 issues the message
Waking up...
. In case
the mains plug has the incorrect polarization a warning will appear in the
display (see section '
Mains phase detection ' on page 14). After that the
unit is in normal operating mode.
If you would like to switch off the unit, please press the power key on the
front panel. First, the display shows the message
Going to sleep..
which then will be replaced by the stand-by text (see section ' Set Off-Text '
on page 25). The unit is now in stand-by mode.
Note
·
Of course, you may switch on/off the PRE G2 with the included
Audionet System Remote Control
Harmony One . For detailed infor-
mation please refer to section ' Screen 3 ' on page 32.