34
Please use setup option 'Set Channel for By-Pass Mode' to select which of the
six input channels of the PRE G2 is fed through to the outputs if By-Pass
Mode is active.
Important
·
First, select the input channel used for By-Pass Mode (see section '
Set
Channel for By-Pass Mode
' on page 26), before you activate the By-Pass
Mode for the first time.
Activate the special function By-Pass Mode of your PRE G2 by pressing
the key
By-Pass Mode
of the Audionet System Remote Control. The
signal at the input channel selected for By-Pass Mode operations is
passed through the PRE G2 at a level of 0 dB (i.e. no change in volume
level) to the outputs.
Important
·
Please check the correct connection and setup before you use the
By-Pass Mode for the first time. The input signal will be passed
through to the outputs at full level!
As soon as the By-Pass Mode is activated, the PRE G2 will ignore all
control commands coming from the keys on the front panel or remote
control (exceptions see below)!
Important
There are only two possibilities to disable the By-Pass Mode:
1.
Press key
By-Pass Mode
of the Audionet System Remote Con-
trol. The PRE G2 switches back to the input channel selected before
resetting the volume to its prior level.
2.
Push the
power
key on the front panel. The PRE G2 switches off to
stand-by mode.
Note
·
If you leave the By-Pass Mode by pushing the
power
key on the
front panel, this mode will
not
be saved, i.e. if you switch on the
PRE G2 again, the unit will switch to the last saved input channel se-
lection and not to the By-Pass Mode. If you would like to use the By-
Pass Mode again, press key
By-Pass Mode
of the Audionet Sys-
tem Remote Control
Harmony One
.
Содержание PRE G2
Страница 1: ...1 Reference Pre Amplifier User s Manual ...
Страница 2: ...2 ...
