Phone 425-775-8461 • www.audiocontrol.com
®
21
Input Confi g
General Setup
Auto Setup
Spkr Types
Spkr Distance
Spkr Levels
Video Inputs
Video Outputs
Mode
Zone Settings
Network
Adjust to compensate for an off-centre listening
position.
Input Confi g
General Setup
Auto Setup
Spkr Types
Spkr Distance
Spkr Levels
Video Inputs
Video Outputs
Mode
Zone Settings
Network
Input
: DVD
Name
: DVD
Lipsync
Mode
: Last Mode
Ext Mode
: Last Mode
Treble
Bass
Room EQ
: Net Calculated
Input Trim
: 2V RMS
Allows individual confi guration of each input.
Input Configuration
Each input on your Concert AVR-1 has individual audio and video settings
that can be adjusted specifically for its use.
INPUT -
Identifies the currently selected input
which settings are being displayed below.
NAME -
Specific name/label for this input that
will show on display device and OSD. Very use-
ful when you have more than one source unit
that may do similar functions (i.e. 2 two Satellite
receivers could be named SAT1 and SAT2 ac-
cordingly)
LIP SYNC -
Many video processors and line mul-
tipliers cause a slight delay between the sound and
the video picture. Highly compressed video signals such as MPEG encoded
satellite receivers and some DVD’s also suffer from this problem. The Lip
Sync setting delays the audio a small amount to allow the video image to
catch up.
MODE -
Sets the initial audio decode mode for
stereo
sources on this input
ExT. MODE -
Sets the initial audio decode mode for multi-channel digital
sources on this input.
TREBLE and BASS -
Changes the bass and treble response for all speakers
when using this input. Very useful when you have a source unit that has
reduced frequency response due to the format (i.e. older VCR’s)
ROOM EQ -
The Auto Speaker Set-Up in the Concert AVR-1 utilizes a
special algorithm that calculates many the major frequency resonance’s
that occur due to room acoustics and speaker locations and creates specific
equalization filters to offset this. This menu allows you to select whether to
engage the Room Equalization filter for each source. Options are “Not Cal-
culated”, “ON” or “OFF” with the default being “Off”.
INPUT TRIM -
Selects the maximum analog signal for this input before
clipping. This setting should match the audio output of your source units
with the available settings being 0.5, 1, 2, and 4 volts RMS and the default
being 2 Volt. Source units with low output levels can benefit from being set
to higher output settings such as .5 or 1V.
n
aVIgaTIng
THe
s
eT
-u
p
M
enus