AudioCodes Mediant 4000B SBC, Руководство по установке оборудования

Страница: 38 / 60

Hardware Installation Manual 38 Document #: LTRT-41749
Mediant 4000B SBC
5.1 Connecting the Ethernet Ports to the LAN
The cabling specifications and procedure for connecting the device to the LAN is as
follows:

Cable: Straight-through, Category (Cat) 5, 5e or 6 cable

Connector: Standard RJ-45

Connector Pinouts:
Table 5-1: RJ-45 Connector Pinouts
Pin Name Description
1 BI_DA+ Bi-directional pair A+
2 BI_DA- Bi-directional pair A-
3 BI_DB+ Bi-directional pair B+
4 BI_DC+ Bi-directional pair C+
5 BI_DC- Bi-directional pair C-
6 BI_DB- Bi-directional pair B-
7 BI_DD+ Bi-directional pair D+
8 BI_DD- Bi-directional pair D-

To connect to the LAN:
1. Connect the RJ-45 port at one end of the cable to an Ethernet port on the SBC
module:
Figure 5-1: Connecting the LAN Interface
2. Connect the other end of the cable to your LAN network.
Note: For initial network connectivity to the device, use ports GE 1 or GE 2 to connect to
the LAN. These ports (or this Ethernet Group) are assigned to the OAMP interface
(192.168.0.2) by default. For port names as well as Ethernet port groups (for 1+1
redundancy), see Section
5.1.1 on page 39 .