AudioCodes Media Pack MP-124, Руководство пользователя

Страница: 60 / 584

User's Manual 60 Document #: LTRT-65422
MP-11x & MP-124
In addition to the color-coded status information depicted on the graphical display of the
device, the Home page displays various read-only information in the General Information
pane:

IP Address: IP address of the device

Subnet Mask: Subnet mask address of the device

Default Gateway Address: Default gateway used by the device

Firmware Version: Software version running on the device

Protocol Type: Signaling protocol currently used by the device (i.e. SIP)

Gateway Operational State:
•
"LOCKED": device is locked (i.e. no new calls are accepted)
•
"UNLOCKED": device is not locked
•
"SHUTTING DOWN": device is currently shutting down
To perform these operations, see 'Basic Maintenance' on page 321 .
The table below describes the areas of the Home page.
Table 4-10: Home Page Description
Label Description
Alarms Displays the highest severity of an active alarm raised (if any) by the device:

Green = no alarms

Red = Critical alarm

Orange = Major alarm

Yellow = Minor alarm
To view active alarms, click this Alarms area to open the Active Alarms page (see
Viewing Active Alarms on page
363 ).
Channel/Ports Displays the status of the ports (channels):

(red): Line not connected or port out of service due to Serial Peripheral
Interface (SPI) failure (applicable only to FXO interfaces)

(grey): Channel inactive

(blue): Handset is off-hook

(green): Active RTP stream
If you click a port, a shortcut menu appears with commands allowing you to
perform the following:

(Analog ports only) Reset the channel port (see Resetting an Analog Channel
on page
325 )

View the port settings (see 'Viewing Analog Port Information' on page 365 )

Assign a name to the port (see 'Assigning a Port Name' on page 61 )
Uplink (MP-11x)
LAN (MP-124
If clicked, the Ethernet Port Information page opens, displaying Ethernet port
configuration settings (see Viewing Ethernet Port Information on page
362 ).
Fail Currently not supported.
Ready Currently not supported.
Power Always lit green, indicating power received by the device.