AudioCodes Media Pack MP-124, Руководство пользователя

Страница: 514 / 584

User's Manual 514 Document #: LTRT-65422
MP-11x & MP-124
43.10.3 Digit Collection and Dial Plan Parameters
The digit collection and dial plan parameters are described in the table below.
Table 43-38: Digit Collection and Dial Plan Parameters
Parameter Description
Web/EMS: Dial Plan Index
[DialPlanIndex]
Defines the Dial Plan index to use in the external Dial Plan file. The
Dial Plan file is loaded to the device as a .dat file (converted using
the DConvert utility). The Dial Plan index can be defined globally or
per Tel Profile.
The valid value range is 0 to 7, where 0 denotes PLAN1, 1 denotes
PLAN2, and so on. The default is -1, indicating that no Dial Plan file
is used.
Notes:

If this parameter is configured to select a Dial Plan index, the
settings of the parameter DigitMapping are ignored.

If this parameter is configured to select a Dial Plan index from an
external Dial Plan file, the device first attempts to locate a
matching digit pattern in the Dial Plan file, and if not found, then
attempts to locate a matching digit pattern in the Digit Map rules
configured by the DigitMapping parameter.

This parameter can also be configured in a Tel Profile.

For more information on the Dial Plan file, see 'Dialing Plans for
Digit Collection' on page
334 .
[Tel2IPSourceNumberMappi
ngDialPlanIndex]
Defines the Dial Plan index in the external Dial Plan file for the Tel-
to-IP Source Number Mapping feature.
The valid value range is 0 to 7, defining the Dial Plan index [Plan x ]
in the Dial Plan file. The default is -1 (disabled).
For more information on this feature, see Modifying ISDN-to-IP
Calling Party Number.
Web: Digit Mapping Rules
EMS: Digit Map Pat terns
[DigitMapping]
Defines the digit map pattern. If the digit string (i.e., dialed number)
matches one of the patterns in the digit map, the device stops
collecting digits and establishes a call with the collected number.
The digit map pattern can contain up to 52 options (rules), each
separated by a vertical bar (|). The maximum length of the entire digit
pattern is 152 characters. The available notations include the
following:

[n-m]: Range of numbers (not letters).

. (single dot): Repeat digits until next notation (e.g., T).

x: Any single digit.

T: Dial timeout (configured by the TimeBetweenDigits parameter).

S: Short timer (configured by the TimeBetweenDigits parameter;
default is two seconds) that can be used when a specific rule is
defined after a more general rule. For example, if the digit map is
99|998, then the digit collection is terminated after the first two 9
digits are received. Therefore, the second rule of 998 can never
be matched. But when the digit map is 99s|998, then after dialing
the first two 9 digits, the device waits another two seconds within
which the caller can enter the digit 8.
An example of a digit map is shown below:
11xS|00T|
[1- 7]xxx|8xxxxxxx|#xxxxxxx|*xx|91xxxxxxxxxx|9011x.T
In the example above, the last rule can apply to International