AudioCodes Media Pack MP-124, Руководство пользователя

Страница: 110 / 584

User's Manual 110 Document #: LTRT-65422
MP-11x & MP-124
Parameter Description
Web/EMS: Primary DNS Server IP
address
[InterfaceTable_PrimaryDNSServerI
PAddress]
(Optional) Defines the primary DNS server's IP address (in
dotted-decimal notation), which is used for translating
domain names into IP addresses for the interface.
By default, no IP address is defined.
Web/EMS: Secondary DNS Server IP
address
[InterfaceTable_SecondaryDNSServ
erIPAddress]
(Optional) Defines the secondary DNS server's IP address
(in dotted-decimal notation), which is used for translating
domain names into IP addresses for the interface.
By default, no IP address is defined.
General Parameters
Web/EMS: VLAN Mode
[VLANMode]
Enables VLANs tagging (IEEE 802.1Q).

[0] Disable (default)

[1] Enable
Notes:

For this parameter to take effect, a device reset is
required.

To operate with multiple network interfaces, VLANs must
be enabled.

VLANs are available only when booting the device from
flash. When booting using BootP/DHCP protocols, VLANs
are disabled to allow easier maintenance access. In this
scenario, multiple network interface capabilities are
unavailable.
Web/EMS: Native VLAN ID
[VLANNativeVLANID]
Defines the Native VLAN ID. This is the VLAN ID to which
untagged incoming traffic is assigned. Outgoing packets sent
to this VLAN are sent only with a priority tag (VLAN ID = 0).
When the Native VLAN ID is equal to one of the VLAN IDs
listed in the Multiple Interface table (and VLANs are
enabled), untagged incoming traffic is considered as
incoming traffic for that interface. Outgoing traffic sent from
this interface is sent with the priority tag (tagged with VLAN
ID = 0).
When the Native VLAN ID is different to any value in the
'VLAN ID' column in the table, untagged incoming traffic is
discarded and all outgoing traffic is tagged.
The default Native VLAN ID is 1.
Note: If this parameter is not configured (i.e., default is 1)
and one of the interfaces has a VLAN ID set to 1, this
interface is still considered the ‘Native’ VLAN. If you do not
wish to have a ‘Native’ VLAN ID and want to use VLAN ID 1,
set this parameter to a value other than any VLAN ID in the
table.
11.2.1 Assigning NTP Services to Application Types
You can associate the Network Time Protocol (NTP) application with the OAMP or Control
application type. This is done using the EnableNTPasOAM ini file parameter.