Audio Precision ATS-2, Начало работы

Страница: 22 / 76

Once you have verified that the line voltage selection is correct, connect
the power cord from a mains power outlet to the power cord connector on
the instrument rear panel.
Fuse Information
The power entry module accommodates two fusing arrangements, as
illustrated in Figure .
§
The North American fusing arrangement uses a single type 3AG
(0.25"
´
1.25") SB (slow blow) fuse.
§
The European fusing arrangement uses two 5
´
20 mm IEC-approved
type T fuses.
Refer to the label on the rear panel for fuse current ratings.
Changing the Fusing Arrangement
To replace a fuse or change the fusing arrangement, proceed as follows:
§
Remove the mains power cord from the power cord connector and
open the Power Entry Module as described above.
§
Using narrow pliers, pull the fuse assembly out of the housing.
§
Change or add the correct fuses as necessary, referring to Figure 6.
Refer to the instrument rear panel for the correct fuse electrical
current rating.
§
Insert the fuse assembly in the housing, with the side of the assembly
that carries the fuse(s) for your desired fusing arrangement facing into
the housing. Press the fuse assembly firmly into the housing.
§
Confirm that the line voltage selection is correct for your mains
voltage and your fusing arrangement.
Once you have verified that the line voltage selection is correct, connect
the power cord from a mains power outlet to the power cord connector on
the instrument rear panel.
Chapter 2: Installation and Setup for APIB Setting Up the ATS-2 Hardware
12 Getting Started with ATS-2
Figure 6. Fuse Block Orientation for North American (100/120 V)
and European (230/240 V) operation..