Audio Precision ATS-2, Начало работы

Страница: 20 / 76

confirm that the input voltage selection and fusing arrangement in the
power entry module are correct for your mains power supply.
Checking the Mains Supply Voltage Configuration
The voltage indicator pin protrudes through one of the four labeled
holes in the module cover to indicate the selected input voltage, as shown
in Figure 2. Check that the indicated voltage matches your mains supply
voltage.
Opening the Power Entry Module
Unplug the power cord from the instrument before changing fuses or
performing any other operations described in this section.
To open the Power Entry Module, refer to Figure 3 and proceed as
follows:
§
Remove the mains power supply cord from the power cord
connector.
§
Locate the slot in the module cover door hinge. The hinge is a the
left side of the cover door, and the slot in the hinge is visible in the
power cord connector cavity. Insert a small screwdriver or similar tool
in the slot and pry the cover door hinge outward. The cover door will
snap out, and then can be pivoted on its hinge for access to the fuse
block assembly and voltage selector card.
Changing the Mains Supply Voltage Configuration
§
Open the Power Entry Module as described above.
Chapter 2: Installation and Setup for APIB Setting Up the ATS-2 Hardware
10 Getting Started with ATS-2
Figure 3. Power entry module door and fuse block.