Audient ASP2802, Руководство по эксплуатации

Страница: 26 / 113

Page -26- © Audient Ltd
Channel Strip
Direct Output Routing cont.
The signal path when in CHANNEL mode is as follows:
Using CHANNEL mode it is possible to combine it with the
CH/DAW flip switch (8) to create a “pseudo in-line” architecture.
When operating in “ psuedo in-line ” mode you can effectively
take the microphone preamplifier or line input (which could be
fed from your external microphone preamplifiers), HPF and
polarity inverter output straight to the direct output and
recording device.
Whilst the line or microphone preamplifier input feeds the direct
output, the channel can be reconfigured to allow monitoring of
the signal pre recording device and/or post.
One possible path is via the alternative cue input (14) which
allows the signal to be recorded to be monitored (prior to
reaching its destination) by sending the channel input (line or
mic) signal to the cue level and pan control (11 & 13) and
finally summing the cue bus into the main mix bus (via the
global control in the centre section above the master fader).
*NOTE that all cue sends will feed the main
mix bus if this control is activated, as it is a
global assign feature. Therefore this operation
cannot be selected on a channel by channel
basis.
This is similar to monitoring your short fader record path on an
in-line console architecture.